You must register to start discussions and comment in the forum.

Categories

RecentTags

Vanilla 1.1.4 is a product of Lussumo. More Information: Documentation, Community Support.

General:
Help trying to setup a SAB GD10A Diseqc switch

Bottom of Page

1 to 3 of 3

  1.  
    • CommentAuthorvjyianni
    • CommentTimeNov 3rd 2008
     
    Hi
    I have a SAB GD10A Diseqc using protocol 1.1 to switch 10 LNB's.
    After spending a few hours trying to set it up, I have come to a stop.
    Any help would be much appreciated.
    Regards,
    Yannis
    • CommentAuthorAdministratorarda
    • CommentTimeNov 4th 2008
     
    Dear Yannis,

    Did you check the DiSEqC Setup manuals for 8 and 16 LNBs which you can find at our "Manual" page?

    The direct links are as below;

    http://www.lyngbox.com/downloads/docs/support/diseqc_8lnb.pdf
    http://www.lyngbox.com/downloads/docs/support/diseqc_16lnb.pdf
    • CommentAuthorPeter
    • CommentTimeNov 6th 2008
     
    Hi vjyianni !

    I don´t know the technical data on your switch. It´s probably a programmable switch you have and then you must know which "mode" it´s programmed in before trying to make the proper settings in the LyngBox.

    Maby it´s this switch you have (see link below)?

    http://www.sabsatellite.nl/productsdetail.php?prod=510

    Many programmable switches are preprogrammed in a "mode" which enables selection of the inputs by using DiSEqC 1.2 motorsettings for the inputs but this feature doesn´t work well on all satellitereceivers. So I recommend that you program your switch for "modes" that allow DiSEqC 1.1 commands (if it isn´t already programmed that way).

    Maby your sab switch is similar to "ASAT DiSEqC 1/10 Switch SW 101D" ?
    In that case you might find some helpful information on the links below.

    http://www.satellite-heaven.de/download/manual.jpg
    http://www.satellite-heaven.de/download/manualback.jpg
    http://www.satellite-heaven.de/testreports/sw101d.htm

    If your switch is programmed in modes for DiSEqC 1.1 then you can use settings for "Other switch" in the LyngBox.

    / Peter

1 to 3 of 3

  1.